Boat Installation

Step 1

Check the boat for any sharp objects that would wear and protrude on the cover. The Boat Covers have extra reinforcing over the windscreen, outboard, aft corners and bow areas, for any other areas ensure these are protected to ensure a long lasting life of the cover.

Step 2

Place the cover over the boat with the label “Front” on the bow.

Step 3

Use the three tie downs with hooks on the aft. Two can be hooked around the trailer and the centre strap around the outboard.

Step 4

Pull both draw strings in evenly and tie off around either the outboard or the trailer. Always ensure this draw string is tight to prevent wind flapping the cover causing abrasion.

Step 5

Install tie downs along each side of cover. One end is fastened on to the cover. Loop male end of the strap under the trailer and back into the female buckle. After installation of straps cut excess length to avoid flapping on side of the hull.

Now that your cover is fitted correctly please ensure the following steps are taken to look after the cover.

Cover Care

Avoid towing with the cover on, this will put stress on seams. Pad any abrasion areas. If not using the cover, ensure it is dry before storing. Always ensure tie down straps are tight to prevent water pooling in the middle of cover.

Cleaning

• Brush off loose dirt.
• Hose down.
• Prepare a cleaning mixture of water and mild soap (no detergents or powerful acid cleaners).
• Use soft bristle brush.
• Allow soap to soak in.
• Rinse thoroughly.
• Air dry.
• After cleaning to enhance water repellency use 3M Scotchgard Water Repellent.

Warranty

The materials and workmanship are guaranteed to be free from defects at the time of manufacture. The warranty does not cover normal wear, weather soiling, oxidization of water repellent, or stains from environmental pollution. The boat cover must be properly secured, maintained , and stored for the warranty to remain in effect. In addition, the boat cover must be utilised for the purpose for which it was intended.

Should you experience any problems with your Cover please notify Cover Systems on 0800 080872

Damage to covers not covered by warranty

Tears or rips caused by not padding sharp or obtrusive objects. Tears or rips caused by improper securing of boat cover to boat and/or trailer during transportation. Allowing water, snow & ice to pool in cover. Discolouring or fabric desecration from foreign objects and chemicals(including tree saps, petroleum products, bird and animal droppings). Mold and/or mildew caused by storage of wet cover. Acts of God. Click here to enquire.